MINER METAL DETECTORS AND HIGH TECH GEOPHYSICAL INSTRUMENTS

HOME  |  MINER A-100  |  MINER A-350  |  MINER A-700  |  MINER A-200  |  MINER A-1000

 

MINER A-700 GEOELECTROMAGNETISM SCANNER

Miner A-700 is used for detecting buried treasure, disturbed soil, gold, metals and metallic mineral deposits.

 

detector

Miner A-700 consists of three parts. There is one receiver and two signal generators (ultra high and ultra low).

 

 

MINER A-700'S MAGNETIC DETECTION PRINCIPLE

 

Digging and filling a hole for burying an object will cause a magnetic difference in earth's natural magnetic field because of the replaced, removed, mixed minerals and the buried metal objects. The disturbed soil's magnitude of magnetism will be higher or lower from its surroundings. After decades, that difference will be detectable by high sensitivity instruments like Miner A-700.

 

define dedektörleri

In the above drawing; a magnetic object enters into a field and causes a deviation in the earth's natural magnetic field.

 

 

 

 

 

The man is doing a research in the field with Miner A-700.

 

The magnetic object buried underground has its own magnetic field which is different from the earth's natural magnetic field.

 

Miner A-700 will detect the magnetic deviation caused by the metallic object and the disturbed (dug and filled) soil. It will start vibrating.

 

The target will be located.

 

 

 

MINER A-700'S ELECTROMAGNETIC DETECTION PRINCIPLE

 

The transmitter in Figure 1 (cizim 1) emits ultra high frequency signals. In Figure 2 (cizim 2), the receiver is getting the signals from the transmitter without any interruption and any interference.

 

 

 

 

In Figure 3 (cizim 3), the radiated radio waves generated by the transmitter are interrupted by the conductive objects such as long-time buried metals. A secondary electromagnetic field occurs around the metal which disrupts the primary electromagnetic field. That secondary field around the metal object underground negatively affects the communication between the receiver and the transmitter. When the receiver detects the weak, distorted field, the metal object will be somewhere between the receiver and the transmitter. The maximum depth of that metal object is equal to the distance between the mobile receiver and the constant (fixed) transmitter.

 

 

MINER A-700 VISUALISATION: The sudden change on 2D geomagnetic field / time graph shows a metal or an anomaly. The power carried by various frequencies is shown on the second 2D graph. The unstable values also indicate an anomaly.

 

MINER A-700 MAGNETIC SCAN: The above picture shows the magnetic research performed in the field by Miner A-700. The magnetic intensity of the soil which is under the interference of ultra high (and low) frequency electromagnetic field generated by the transmitter, is measured in three axis (x, y, z). Then the absolute value is calculated by Miner A-700 and displayed. In the above example, 45 microtesla is the common intensity of magnetism in the field. A sudden increase in the figure such as 60 microtesla indicates a target underground.

 

MINER A-700 ELECTROMAGNETIC SCAN: The above picture shows the electromagnetic research performed in the field by Miner A-700. The signal generator is fixed on or a few centimeters under the ground level. The researcher begins scanning at constant speed while holding the receiver on his hand. The figures displayed are 47, 49, 50. When he reads a sudden increase (or decrease) on the screen like 99, he stops. He measures the distance between the transmitter and himself. The result of this measurement is the maximum depth of the potential target underground. The exact location of the target would be right under his feet or any point between the receiver and the transmitter.

 

MINER A-700 ELECTROMAGNETIC SCAN (practical): The above picture shows the practical electromagnetic research performed in the field by Miner A-700. The signal generator and the receiver are fixed on a flat board. The researcher begins scanning at constant speed while holding both units on his hand. The figures displayed are 30, 30, 30, etc. When he reads a sudden increase on the screen like 80, he stops. The exact location of the target would be right under the receiver and the transmitter.

 

 

MAGNETIC ANOMALY EXPERIMENT

(a) The mineral content of the soil is different on the surface (yerustu) and in the underground (yeralti). There are layers of soil that has various magnetic magnitudes of 100 and 50 units.                                  

(b) We dig a hole, move the soil aside. The soil aside is a mixture of magnetic minerals that has a magnitude of 90 units.

 

(c) We put an object into the hole.

 

(d) We fill the hole with the mixed soil. The object is buried.

 

 

(e) The removed and replaced soil content is different from its surroundings. It will rain, snow, etc. The soil will be under the influence of temperature and pressure.

(f) The earth's magnetic field will change in the following decades. The magnetism of the dug & filled soil will also change. The magnetic difference between the dug & filled soil (with the object) and its surroundings will increase and it will be detectable by high sensitivity instruments like Miner A-700.

 

The communication between the transmitter and the receiver can break up because of the underground conductive materials (such as treasure, metals, gold, metallic minerals). A secondary electromagnetic field occurs around the material which disrupts the primary electromagnetic field.

 

 

 

HOME  |  MINER A-100  |  MINER A-350  |  MINER A-700  |  MINER A-200  |  MINER A-1000

 

OZDEMIRLI TIC. LTD. STI. Uzgorenler Sok. No.14 P-7 Demirlibahce Ankara TURKEY

Tel: +90 (545) 363 71 05   /  +90 (505) 460 83 70 

 E-mail: info@metaldedektor.net

 

(c) Copyright 1996-2018 MINER, manufacturer of high technology metal detectors gold detectors treasure detectors geophysical instruments magnetometers gradiometers resistivity meters gravity meters electromagnetism scanners mineral ground water detectors locators gpr